The larger the non-woven fabric manufacturer, the more they understand the importance of the preparation work before the production of the non-woven fabric. Doing a good job in the pre-production work of the non-woven fabric can not only ensure the processing quality of the non-woven fabric, but also reduce the Errors and emergencies in various links in the production process are conducive to improving the production and processing efficiency of non-woven fabrics. So what do you need to prepare before the production of non-woven fabrics?
1. Put the rewinding stick in place, first start the power of the host machine and the frequency conversion controller, and then slowly rotate the frequency conversion speed control switch.
2. If you need to count, you can arbitrarily set the number of pieces or meters you want on the counter.
3. According to the characteristics of various non-woven fabrics, adjust the two tensions of the fabric so that the fabric is neither tight nor loose.
4. If the non-woven fabric is not evenly punched, it can be adjusted through the adjustment device of the spiral punching knife until it is uniform.
5. If the non-woven fabric is too loose or not tight, it can be adjusted by the non-woven fabric air pressure adjustment device.
6. Carry out trial operation: After turning on the machine, increase the speed appropriately, and observe whether the adjustment results of the above steps are normal. If not, continue to adjust the previous steps; if normal, set the production speed to the machine folding state.
Before the production and processing of non-woven fabrics, the preparation work that needs to be done must be taken seriously, because if the preliminary preparations are not sufficient, it will affect the smooth progress of the production and processing of non-woven fabric products, so the preliminary preparations cannot be ignored and hasty!